Cover screws on Beer Flight

[tjmarino85]

Should I leave the screws as is (Sunk In) or should I use some type of cover, if so what type of cover? I was thinking felt pad, but for the diameter I need they are pretty think, unless I am looking at the wrong ones. Thanks

 

[Ian]

It's up to you - unless someone turns the beer flight upside down, then won't see them - countersunk is just fine . Adding felt or thin rubber pads means you could hide them and also protect whatever surface you sit it on. Perhaps rubber pads would be a better choice if it's going to go in a bar setting, as they'll get wet at some point!