Craft Power Router Bits

[Ozzer]

I have a fairly old (ancient!) Craft Power Router PBF-1050E which still works very well but the cutters need replacing. Can anyone tell me which cutters I should buy esp. the shank diameter as I can't seem to find anything that fits online.
Many thanks in anticipation

 

[Retired]

Hi,

Welcome to the forum Ozzer.

https://www.manualslib.com/manual/1190904/Power-Craft-Pbf-1050e.html

Your router should have two collets; 6 & 8mm if you have both collets then either size will fit; the 6 & 8mm are the cutter shank sizes you need? You can also measure the collet bore. Page 3 in the manual.

Hope this helps.

Kind regards, Colin.