Supplier of small toothed belts?

[Newshound]

Anyone know a supplier of small toothed belts, typically 10 mm wide?

My Chester mini-lathe nominally takes a 1.5 x 70 x 10, but it is very
tight and I've just half shagged a new replacement in five minutes of
relatively light duty. I reckon I need one two or three teeth longer. No
obvious scope for correcting the centres error because it seems to be
set by borings in the casting, but I could probably add a tensioner if
the next length up is too long.

So far I've only located suppliers for cam-belt size upwards.

TIA

 

[The Other Mike]

Anyone know a supplier of small toothed belts, typically 10 mm wide?

My Chester mini-lathe nominally takes a 1.5 x 70 x 10, but it is very
tight and I've just half shagged a new replacement in five minutes of
relatively light duty. I reckon I need one two or three teeth longer. No
obvious scope for correcting the centres error because it seems to be
set by borings in the casting, but I could probably add a tensioner if
the next length up is too long.

So far I've only located suppliers for cam-belt size upwards.

http://www.hpcgears.com/


--

 

[Newshound]

http://www.hpcgears.com/

Brilliant, looks just the job, thanks very much