Genie SD9500 opener lights

Discussion in 'Misc DIY' started by 3250man, Dec 24, 2006.

  1. 3250man

    3250man Guest

    HELP!! I have an older model Genie (SD9500) garage door opener.
    Lately, when I either open/close the door, the 2 lights stay lit. (pas
    the normal 5 minute time delay). Do I need a new sequensor board
    $45-$50 seems like a lot to turn off two light bulbs! Previous hom
    owner didn't leave a schematic for the opener and the Genie homepag
    isn't any help
    THANKS in advance
    Ji
     
    3250man, Dec 24, 2006
    #1
    1. Advertisements

  2. 3250man

    Liz Megerle Guest

    I posted a similar question recently. The collective wisdom was that a
    relay is sticking. Next time it happened, I gave the unit a whack on
    the side. The light went off and the problem hasn't recurred.
    Liz
     
    Liz Megerle, Dec 24, 2006
    #2
    1. Advertisements

  3. 3250man

    shoetrrs Guest

    shoetrrs, Dec 25, 2006
    #3
  4. 3250man

    3250man Guest

    Liz,
    Thanks for the info/idea. I removed the card and "whacked" it a fe
    times (on the relay- module-appearing thingies). IT WORKED!! Light
    go on and off as they are supposed to
     
    3250man, Dec 25, 2006
    #4
  5. 3250man

    maryg3

    Joined:
    Aug 5, 2018
    Messages:
    3
    Likes Received:
    0
    Where is the relay for the genie sd9500?
     
    maryg3, Aug 5, 2018
    #5
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.